| Opcode/Instruction | Op/En | 64/32-bit Mode | CPUID Feature Flag | Description |
|---|---|---|---|---|
|
F3 0F 2D /r CVTSS2SI r32, xmm/m32 |
RM | V/V | SSE | Convert one single-precision floating-point value from xmm/m32 to one signed doubleword integer in r32. |
|
F3 REX.W 0F 2D /r CVTSS2SI r64, xmm/m32 |
RM | V/N.E. | SSE | Convert one single-precision floating-point value from xmm/m32 to one signed quadword integer in r64. |
|
VEX.LIG.F3.0F.W0 2D /r VCVTSS2SI r32, xmm1/m32 |
RM | V/V | AVX | Convert one single-precision floating-point value from xmm1/m32 to one signed doubleword integer in r32. |
|
VEX.LIG.F3.0F.W1 2D /r VCVTSS2SI r64, xmm1/m32 |
RM | V/N.E.1 | AVX | Convert one single-precision floating-point value from xmm1/m32 to one signed quadword integer in r64. |
NOTES:
1. Encoding the VEX prefix with VEX.W=1 in non-64-bit mode is ignored.
| Op/En | Operand 1 | Operand 2 | Operand 3 | Operand 4 |
| RM | ModRM:reg (w) | ModRM:r/m (r) | NA | NA |
Converts a single-precision floating-point value in the source operand (second operand) to a signed doubleword integer (or signed quadword integer if operand size is 64 bits) in the destination operand (first operand). The source operand can be an XMM register or a memory location. The destination operand is a general-purpose register. When the source operand is an XMM register, the single-precision floating-point value is contained in the low doubleword of the register.
When a conversion is inexact, the value returned is rounded according to the rounding control bits in the MXCSR register. If a converted result is larger than the maximum signed doubleword integer, the floating-point invalid exception is raised, and if this exception is masked, the indefinite integer value (80000000H) is returned.
In 64-bit mode, the instruction can access additional registers (XMM8-XMM15, R8-R15) when used with a REX.R prefix. Use of the REX.W prefix promotes the instruction to 64-bit operands. See the summary chart at the begin-ning of this section for encoding data and limits.
Legacy SSE instructions: In 64-bit mode, Use of the REX.W prefix promotes the instruction to 64-bit operands. See the summary chart at the beginning of this section for encoding data and limits.
Note: In VEX-encoded versions, VEX.vvvv is reserved and must be 1111b, otherwise instructions will #UD.
IF 64-bit Mode and OperandSize = 64
THEN
DEST[64:0] ← Convert_Single_Precision_Floating_Point_To_Integer(SRC[31:0]);
ELSE
DEST[31:0] ← Convert_Single_Precision_Floating_Point_To_Integer(SRC[31:0]);
FI;
int _mm_cvtss_si32(__m128d a)
__int64 _mm_cvtss_si64(__m128d a)
Invalid, Precision.
See Exceptions Type 3; additionally
| #UD | If VEX.vvvv ≠ 1111B. |